|
|
|||
|
|
|
||
|
|
|||
|
Green-Guard™ reduces labor costs and can even be cut with a hacksaw* using standard procedures. |
|
Green-Guard™ can be bent with standard benders and shoes. Green-Guard will not flake even when temperatures are as low as –20°C (-4°F). |
|
|
|
|
||
|
With Green-Guard™, threading follows standard procedures. As a result, no special conduit end preparation is required to permit the engagement of threading dies, thus saving labor installation costs. |
|
Seal all joints with Green-Guard™ touch-up compound to stop the penetration of corrosion inside your system. |
|
|
|
|||
|
· Cover forks of lift truck with cushioning materials.
· Use non metallic slings for hoisting conduit bundles.
· Avoid rubbing or sliding any material against Green-Guard™ surfaces.
· Ensure pallets, skids and racking are free from rough surfaces and covered with cushioning materials.
· After bundles or cartons are opened, ensure the remaining items are separated by the cushioning material. |
|||
|
|
|||
|
|
|||
|
Repairing |
|||
|
|
|||
|
· Rub surface using fine sand paper.
· Clean surface using Green-Guard™ cleaner # CLG-500.
· Apply primer reactive vinyl paint Green-Guard™ # 2444-10. Let dry for 30 minutes.
· Apply primer paint Green-Guard™ # 2570-10. Let dry for 60 minutes.
· Apply Green-Guard™ touch-up compound # TUG-20. |
|||
|
|
|||
|
Please note repairs have to be done at temperatures above 13°C (58°F). |
|||
|
*If Green-Guard™ conduit is to be held in a vise or jaws while cutting or threading, we recommend the use of a non metallic insert or spacer to avoid damaging the pipe unnecessarily. |
|||
|
|
|||
|
|
|||
